The year-end order impulse of the hottest machine

The year-end order impulse of the machine tool industry was cautiously optimistic in 2010

at present, a survey shows that more than 80% of the machine tool enterprises reported an increase in orders in December 2009. This proportion increased significantly compared with November. The output growth rate of the machine tool industry in December also reached a new high this year. According to statistics, the year-on-year growth rate of metal cutting machine tools in December 2009 reached 43.66%, a new high in 2009, and also a new high in the past three years

tail raising factors and new factors jointly influence

analysts believe that this is mainly due to the joint influence of tail raising factors and new factors. First, downstream enterprises have centralized procurement at the end of the year; Second, the gradual improvement of the macro-economy also made the enterprises with strong wait-and-see mood before signing the contract, especially the southern enterprises, which were larger than those producing aerospace aluminum alloy plate and strip; Third, the salesperson also has subjective factors to promote products due to the backward technology and the assessment at the end of the year

from the perspective of tail raising factors, the output growth rate of the machine tool industry in December 2008 was -28.80%, which was the second lowest growth rate in recent years, resulting in a low base effect; From the perspective of new factors, the new growth rate of the output of the detector industry of machine tools to judge the quality state of materials under dynamic load in December 2009 also benefited from the "high boom" of downstream products such as automobiles and construction machinery in 2009: from the perspective of statistics, the output of automobiles, excavators, scrapers and other products reached a record high in 2009. The machine tool industry will significantly benefit from the "conduction" market. Therefore, the new high of machine tool production in December 2009 is not only caused by the tail raising factor, but also affected by new factors, that is, the machine tool industry is being affected by the following one of the main agenda of the conference. The growth rate of CNC machine tools has fallen slightly, but still maintained a high growth rate

from the situation of CNC metal cutting machine tools, the year-on-year growth rate of output in December 2009 was 38.09%, lower than that in November (57.05%). Some analysts believe that this is mainly affected by tail warping factors: in 2008, the output data of CNC machine tools was high, resulting in a relatively low output growth rate in December 2009

in terms of the output growth rate of CNC machine tools, the output growth rate of CNC machine tools is ahead of that of the whole machine tool industry: the low point of the output growth rate of CNC machine tools appeared in November 2008, while the output growth rate of the whole machine tool industry appeared in January 2009; The peak of output growth of CNC machine tools in 2009 appeared in November, while the peak of output growth of the machine tool industry appeared in December

in terms of the proportion of NC machine tool output in the output of the machine tool industry, the proportion of NC machine tool output basically remained at about 20% from November 2007 to June 2009, but in the fourth quarter of 2009, the proportion of NC machine tool output in the output of the machine tool industry showed an accelerated upward trend, reaching about 27% in December 2009, although the proportion of NC machine tool output in the output of the machine tool industry continued to increase, However, compared with the average level of about 60% in developed countries, the numerical control rate of output in China's machine tool industry is still low, and there is still much room for growth in the next few years